Rulomix is developed and reinforced by special fillers and additives has high covering capacity and good adhesion power. Resists to uv, sun light, abrassion, impact, discoloration and crack water vapor diffusible as well. Various texture can be obtained by using special rollers and different consistency. Produced in various colors.

Rulomix is packed in metaul or plastic buckets. It is in confirmity with ts 7847

Rulomix is used as decorative coating on plastered, concrete, mineral coated, firm old self supporting acylic painted and tekas complete heat insulation applied surfaces, to cover minor defects of plaster as well.

Fine texture 1.2 kg/m2 , coarse texture 2.0 kg/m2

Shelf life, in unopened packs, under normal heat (projecter from direct sun light and frost) is 6 months.

Surfaces should be free oil, dirt, dust and loose particles old blistered surfaces should be cleaned by steel brush, rasp or mechanical disk. Newly plastered surfaces should be left to dry 2-4 weeks. All surfaces should be primed by tekastar-s and left to dry min 6 hours. Rulomix is applied by various rollers to achieve required texture. Texture depends on type of roller and consistancy of coating. Application should be avoided from heat, direct sun light, rain. Temperature should be in the internal of + 50 c and +250 c. Tools are washed by clean water.

RECOMMANDATIONS:

• To avoid from slight discolorations care should be paid to use the same numbered and dated cans on each facade.
• By any means in case of water loss in Rulomix only clean water to reach required consistency.
• Drying period is 6-24 hours ( at 200 c)


TECHNICAL CARACTERSITICS :
• Resistance to stripping : dry > 3.20 kgf
• Wet and dry > 3.50 kgf
• Frost and than> 4.40 kgf
• Water absorption : < 0.5 kg/(cm2 h 0.5 )
• Ph :8-9
• Diffusion of vapor :> 3.58 m-1
• Referance standart TS 7847